Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
This annunciator is located to
the right of the weight display
and is used to indicate that
the displayed unit of weight
measurement is kilograms.
This annunciator is located to
the right of the weight display
and is used to indicate that
the displayed unit of weight
measurement is grams.
This annunciator shows that
the display is in the Count
mode and the value displayed
is in pieces (the count
quantity) and not weight.
This annunciator shows that
the displayed value is the
content of the accumulator.
This annunciator is used to
signal that a remote key
function has been activated.
Note that this annunciator is
active only when the Digital
Input feature has been
enabled. Refer to the d in
parameter in Setup.
This annunciator is used to
signal that the displayed
weight is less than the
minimum value of acceptable
weight used in the
Checkweigher feature or that
preset 1 is active.
Note that this annunciator is
active only when the
Checkweigher feature or the
preset feature has been
enabled. Refer to the d oUt
parameter in Setup.
To Next Page
Loading...