Model 190 Installation, Technical and Operation
8400-M022-O1 Rev J
This annunciator is used to signal
that the displayed weight is within
the acceptable weight limits for the
Checkweigher feature.
That is, the weight is equal to or
greater than the minimum
acceptable weight and equal to or
less than the maximum acceptable
weight.
This annunciator is also used to
indicate that preset 2 is active.
Note that this annunciator is active
only when the Checkweigher feature
or the preset feature has been
enabled. Refer to the d oUt
parameter in Setup.
This annunciator is used to signal
that the displayed weight is equal
to or greater than the minimum
value of overweight used in the
Checkweigher feature
This annunciator is also used to
indicate that preset 3 is active.
Note that this annunciator is active
only when the Checkweigher feature
or the preset feature has been
enabled. Refer to the d oUt
parameter in Setup.
To Next Page
Loading...