212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
PWC Weighing Procedure
1. With the scale empty, verify the scale is showing 0 units
Gross. If not in Gross mode, press the 0 key then the TARE
key to clear the stored tare weight and the indicator will
display Gross weight.
2. If the scale is showing a weight different than 0, press the
ZERO/CLEAR key to zero the scale.
3. If you wish to use a tare weight, place a tare weight on the
scale then press the TARE key; Or if you know the tare
weight, you can manually enter it by keying in the value
followed by the TARE key.
4. Place a material to be weighed on the scale. If weight
exceeds any of the Preset weight values, the associated
display annunciators will turn on along with the respective
PWC outputs. (Ex: if presets PWC1 = 1000, PWC2 = 2000
and the weight placed on the scale is 1500, PWC1 would be
on and PWC2 would not).
5. You can add material as desired until the required target
preset value is reached.
6. Repeat these steps for subsequent PWC iterations. If you
wish to continue using the stored tare weight, skip steps 1 to 3.
To Next Page
Loading...