212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
11. If you wish to check how much material is remaining on the
scale, switch to Load mode by pressing the LOAD/UNLOAD
key.
NOTE: The displayed Unload weight will be lost when you do
this and cannot be done in the middle of a fill cycle. Press the
LOAD/UNLOAD key again to switch back to Unload mode
before starting the next cycle.
12. If you have a value set for PURGE above, the indicator will be
counting the number of fill cycles completed and once the purge
count (PURGE value) is reached, the purge weight (P-WGT) will be
added to the trim weight and flash PURGE FEEDER on the display.
At this time, you would need to manually purge your feeder into
the last container.
To Next Page
Loading...