212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
3. Pressing the MEM key will display the weight accumulator
associated with the previously displayed ID. Notice now which
display annunciators are active.
a. The MEM annunciator signifies the displayed information is
being read from memory.
b. The ACCUM annunciator signifies the displayed information
is a weight accumulation.
c. The 1 annunciator signifies the displayed information is from
ID list 1.
4. Pressing the F key will toggle between ID lists. Notice which
display annunciators are active
a. The MEM annunciator signifies the displayed information is
being read from memory.
b. The ID annunciator signifies the displayed information is an
ID name.
c. The 2 annunciator signifies the displayed ID is from list 2
(Plot ID List).
5. Pressing the RECALL key will advance to the next ID in the
currently displayed list.
6. Pressing the key will exit the review menu and return to the
weight display.
Selecting a Stored Box ID using the RECALL key:
1. Make sure the indicator is displaying weight in LOAD mode. If
the indicator is not in LOAD mode, press the LOAD/UNLOAD
key to toggle LOAD mode.
2. From the weight display, press the RECALL key repeatedly until
your desired box ID is displayed and then press ENTER to
select it.
3. The indicator will display the box ID’s target weight for 3
seconds and then display the net weight remaining in the box ID
you selected.
To Next Page
Loading...