212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
Selecting a Stored Plot ID using the RECALL key:
1. Verify the scale is in Load mode (the Unload annunciator will be turned
off). You can toggle back and forth between Load and Unload mode
by pressing the LOAD/UNLOAD key.
2. Press the RECALL key. The first box ID will be displayed.
3. Press the F key to toggle the ID type. The first plot ID is now displayed
(pressing the F key again will toggle back to displaying box IDs).
4. Press the RECALL key repeatedly until your desired plot ID is
displayed, then press ENTER to select it.
Selecting Box and Plot ID’s using the ID key:
1. Verify the scale is in Load mode (the Unload annunciator will be turned
off). You can toggle back and forth between Load and Unload mode
by pressing the LOAD/UNLOAD key.
2. Press the ID/START key. The indicator will prompt BOX=. Use the
alpha-numeric keys to key in your desired box ID then press ENTER.
3. The indicator will prompt PLOT=. Use the alpha-numeric keys to key in
your desired plot ID then press ENTER.
4. The indicator will display the box ID’s target weight for 3 seconds, then
display the net weight remaining in the box ID you selected.
Recalling a Stored Box ID for Editing:
1. Press the MEM key followed by the RECALL key. The first box ID is
displayed.
2. Continue pressing the RECALL key until your desired box ID is
displayed, then press ENTER.
3. Follow steps 3-5 from the section “Storing a Box ID” above to edit the
stored ID values.
To Next Page
Loading...