212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
Recalling a Stored Plot ID for Editing:
1. Press the MEM key followed by the RECALL key. The first box
ID is displayed.
2. Press the F key to toggle the ID type. The first plot ID is
displayed.
3. Continue pressing the RECALL key until your desired plot ID is
displayed, then press ENTER.
4. Follow steps 4-5 from the section “Storing a Plot ID” above to
edit the stored ID values.
Editing a Stored ID by Keying the ID:
1. Press the MEM key. The indicator will prompt ID=.
2. Use the alpha-numeric keys to key in the box ID or plot ID that
you wish to edit, then press ENTER.
3. Edit the stored values by following:
a. Steps 3-5 from the section “Storing a Box ID” if you keyed in
a box ID.
b. Steps 4-5 from the section “Storing a Plot ID” if you keyed in
a plot ID.
DFC Preset Setup Procedure (Unload Mode Only):
1. A box ID and a plot ID must be selected prior to starting a fill
operation. Follow one of the procedures from the previous
section Storing/Reviewing/Selecting/Editing Memory
Locations in Plot-Tracker DFC Mode to select the 2 ID’s you
wish to use.
2. Verify your desired fill weight is stored in the indicator by
pressing the PRESET key.
3. The display will read FILL=. This is the target fill weight. Press
the ENTER key to display the current value. If this value is
correct, press the ENTER key to accept otherwise key in your
desired fill weight then press ENTER.
To Next Page
Loading...