212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
Deselecting a Selected ID:
1. While displaying weight and if an ID is selected, you can deselect it
by pressing the key. The ID and MEM display annunciators will
blink twice alternating one at a time to signify that the current ID has
been deselected.
Using Memory IDs to Accumulate Weight:
1. With an ID selected, press the PRINT/ACCUM key. The current
weight displayed will be added to the selected ID's accumulator and
the ID's count will be incremented.
2. Or if you wish to use the Auto-Accumulate feature of the DFC or Auto-
Hold functions, simply select an ID by either of the 2 methods
described above before starting a DFC or Auto-Hold process and the
final weight will be added to the selected ID's accumulator at the end of
the cycle. The ID's weight counter will as well be incremented.
Clearing a Single ID's Accumulator/Counter:
1. Enter the “ID Review” mode by pressing the RECALL key from the
weight display.
2. Continue stepping through the stored memory list by pressing the
RECALL key until the ID whose accumulator you wish to clear is
displayed.
3. Press the MEM key to display the current accumulation associated
with that ID.
4. With the ID's accumulator displayed, press the ZERO/CLEAR key.
5. The indicator will display prompt CLRACC (clear accumulator?). Press
the ENTER key to respond to this prompt. The default answer to this
question is NO. To confirm you want to clear the annunciator, press
the 1/YES key then press the ENTER key. If you answered NO, the
accumulators will not be cleared. If you answered YES, the
accumulator and the weight counter associated with that ID will be
reset to 0.
6. The indicator will return to “ID review” mode and display the ID you
were modifying.
7. Press the key to exit this mode.
To Next Page
Loading...