212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
Erasing a Stored ID:
1. While displaying weight press the RECALL key to enter “ID
Review” mode.
2. Continue stepping through the stored memory list by pressing
the RECALL key until the ID you wish to erase is displayed.
3. Press the ZERO/CLEAR key.
4. The indicator will display prompt CLR ID (Clear ID?). Press the
ENTER key to respond to this prompt. The default answer to
this question is NO. To confirm you want to clear the ID, press
the 1/YES key and then the ENTER key. If you answered
YES, the stored ID is no longer in memory. If you answered
NO, the memory is not affected.
5. No matter the answer, the indicator will exit “ID Review” mode
and return to displaying weight.
Printing a Single Stored ID:
1. While displaying weight press the RECALL key to enter “ID
Review” mode.
2. Continue stepping through the stored memory list by pressing
the RECALL key until the ID you wish to print is displayed.
3. Press the PRINT/ACCUM key.
4. The indicator will print that ID, accumulator, and weight counter
in the format shown below.
5. Press the key to exit this mode.
11:14 AM 02/08/2011
ID: COWS
Last Wt: 2032 LB
Accum Wt: 14876 LB
Weigh Cnt: 8
To Next Page
Loading...