212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
This is a dual function key. Pressing it alone will prompt
for an ID to be entered.
When using the Digital Fill Control feature, pressing the
F key and then this key (START) will start the fill
operation.
Pressing this key will add the current weight to the
accumulator in use and display the accumulated weight.
Pressing this key a second time will print and return to
the weight display mode.
Pressing the F key before this key will perform a print
only.
NOTE: This key will be disabled while the hold
annunciator is on.
The HOLD key is used to lock and unlock the weight
display. Pressing this key (after obtaining a stable
weight) will cause the indicator to lock onto the weight.
To indicate that the weight display is locked, the 212 will
show HOLD on the right of the display. The 212X will turn
on the HOLD annunciator.
Pressing this key again will unlock the weight display
and return it to the weight display mode.
The TARE key is a dual function key. Pressing the
TARE key alone will store the current gross weight as a
new tare weight and cause the weight display to change
to the net weight display mode. This is known as
Pushbutton Tare mode.
Pressing the key after entering a numeric value
(Keypad Tare) will cause the value entered to be
accepted as a new tare weight.
NOTE: Tare weights equal to or greater than scale
capacity cannot be entered. In addition, keypad tare
weight division value must be same as scale division
value. For example, a unit with 5 lb as division value
will display Error if you enter 3 for tare weight.
To Next Page
Loading...