212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
This is the ZERO annunciator. It is turned on
to indicate that the weight displayed is within
± 1/4 division of true zero.
This is the STABLE weight annunciator. It is
turned on when the weight display is stable.
When off, it means that the change in
successive weight samples is greater than
the motion limits selected during setup.
To indicate the current displayed weight is
held (using either the HOLD key or the Auto-
Hold feature), the 212 will show HOLD on the
right of the display. The 212X will turn on the
HOLD annunciator.
To indicate the current displayed value is a
summation, the 212 will show TOL on the right
of the display. The 212X will turn on the
TOTAL annunciator.
To indicate the scale is in UNLOAD mode,
the 212 will show UnLoaD on the right of the
display. The 212X will turn on the UNLOAD
annunciator.
To indicate the current displayed weight is
Net weight (Gross weight less Tare weight),
the 212 will show N on the right of the
display. The 212X will turn on the NET
annunciator.
To indicate the current displayed weight is
Gross weight, the 212 will show G on the
right of the display. The 212X will turn on the
GROSS annunciator.
Note that Gross weight will be displayed
when no tare weight is stored.
To Next Page
Loading...