212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
To indicate the current displayed weight is the Tare
weight, the 212 will show T on the right of the
display. The 212X will turn on the TARE
annunciator.
This annunciator is located to the right of the weight
display and is turned on to show that the displayed
weight unit is pounds.
This annunciator is located to the right of the weight
display and is used to indicate that the displayed
unit of weight measurement is kilograms.
To indicate the battery does not have a sufficient
charge, the 212 will turn on the (asterisk) on the
lower left side of the display. The 212X will turn on
the LoBat annunciator.
IMPORTANT! When the battery voltage
drops to a level where operation is affected,
the indicator will display this message and
automatically turn OFF.
These numeric annunciators are turned on to signal
that the corresponding PWC output is active.
The ID annunciator is turned on to indicate that the
value displayed is the identification number
currently in use.
To Next Page
Loading...