212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
Installing the Wall Bracket
Refer to Figure No. 6 for a layout of the wall bracket mounting holes.
1. Make certain the mounting surface is strong enough to support
the indicator and that the mounting location is where the
display can easily be viewed while being close enough to
provide the operator easy access to the keypad.
2. Position the wall bracket with the wider end at the top and
mark the desired mounting location.
3. Using the wall bracket as a template, mark the mounting hole
locations and drill the holes.
4. Install the screws through the wall bracket and securely tighten.
5. Insert the narrow end of the indicator bracket into the wide end
of the mounted wall bracket and pull down into place.
To Next Page
Loading...