212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
Full Setup and Configuration
1. Press the ON/OFF key to turn the indicator ON.
2. Press the F key (display will show F— ) and then press the 0/NO key.
3. The display will change to the QUICAL prompt.
4. With QUICAL displayed, press the ENTER key. The display will change
to show the current setting NO.
6. Press the ENTER key.
7. The SetUP menu prompt will be displayed.
8. Proceed with the setup and configuration pressing the F key to step to
the beginning point of each setup section.
Setup Mode (starts at USA= prompt)
Analog to Digital Filtering (starts at dFLt= prompt)
Calibration (starts at CMODE= prompt)
Serial Input/Output (starts at bAUd= prompt)
Print Tab Settings (starts at Port= prompt)
Display High Resolution Weight
Key Lockout Feature Setup
NOTE: With the exception of the SEtUP menu prompt, the prompts
displayed for each menu section are different if you press the F key to
advance to the next menu instead of pressing the ENTER key to step
through the prompts of each section.
For example, if you press the F key with the SEtUP displayed, the next
prompt displayed will be A-d. If you step through the setup prompts by
pressing the ENTER key, the next prompt displayed will be A-d?.
Note that at a prompt with the question mark (?) displayed, you must
press the ENTER key, the 1/YES key and then the ENTER key again to
proceed with that section.
To skip the section and advance to the next menu selection, press the
ENTER key twice.
To Next Page
Loading...