Cardinal 212 Series - Page 56

212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
Page 48
dPP= (Decimal Point Setting)
NOTE: This prompt will ONLY be displayed if Interval is less than 10.
Press the ENTER key to show the current setting. If the setting
displayed is acceptable, press the ENTER key again to save it.
Otherwise, use the numeric keys to enter a new setting and then
press the ENTER key to save it. Allowable settings are 0 to 3.
0 = XXXXXX
1= XXXXX.X
2 = XXXX.XX
3 = XXX.XXX
CAP= (Capacity)
Press the ENTER key to show the current setting. If the setting
displayed is acceptable, press the ENTER key again to save it.
Otherwise, use the numeric keys to enter a new setting and then
press the ENTER key to save it.
Allowable settings are: 1 through 999,999.
Unit2= (Weighing Unit 2)
Press the ENTER key to show the current setting. If the setting
displayed is acceptable, press the ENTER key again to save it.
Otherwise, use the numeric keys to enter a new setting and then
press the ENTER key to save it. Allowable settings are 0 to 6.
0 = none
1= tn (tons)
2= g (grams)
3 = lb (pounds)
4 = oz (ounces)
5 = kg (kilograms)
6 = tonnes (metric tons)
NOTE: The selection for Unit2 can not be the same as
Unit1. In addition, dependent upon the selection for Unit1,
the interval and decimal point settings, not all unit
combinations are available.