212/212X Installation & Technical
8200-M639-O1 Rev D 09/14
FIL-AA (Digital Fill Control Auto-Accumulate)
Press the ENTER key to show the current setting. If the setting displayed
is acceptable, press the ENTER key again to save it. Otherwise, using the
numeric keys, 0/NO or 1/YES, enter the new setting and then press the
ENTER key to save it.
PURGE= (Number of Fill Cycles before feeder will be manually purged)
Press the ENTER key to show the current setting. If the setting
displayed is acceptable, press the ENTER key again to save it.
Otherwise, using the numeric keys, enter the new setting and then press
the ENTER key to save it. Allowable settings are 0 to 99 with 0 disabling
the Purge.
If PURGE is enabled (PURGE=1 to 99), proceed to the setup prompt
P-WGT= to continue setup.
If PURGE is disabled (PURGE=0), proceed to the setup prompt SPEED to
continue setup.
P-WGT= (Purge Weight – amount of material contained in feeder before purge)
Press the ENTER key to show the current setting. If the setting
displayed is acceptable, press the ENTER key again to save it.
Otherwise, using the numeric keys, enter the new setting and then press
the ENTER key to save it.
SPEED= (Digital Fill Control – Number of Speeds)
The 212/212X Digital Fill Control may be configured for either single
speed (SPEED=1) or two speed (SPEED=2) filling operation.
Press the ENTER key to show the current setting. If the setting
displayed is acceptable, press the ENTER key again to save it.
Otherwise, using the numeric keys, enter the new setting and then press
the ENTER key to save it. Allowable settings are 1 or 2.
1. If SINGLE SPEED OPERATION is selected (SPEED=1), proceed to the
setup prompt A-TRIM to continue setup.
2. If TWO SPEED OPERATION is selected (SPEED=2), proceed to the
setup prompt GATE= to continue setup.
To Next Page
Loading...