Cardinal 225 - Page 101

8200-M698-O1 Rev B  225 Installation and Technical
93
ID STORAGE SETUP, CONT.
3.PROMPT 1= (PROMPT 1 NAME)
With the ID Storage Menu displayed the current setting for the PROMPT 1=
parameter will be shown. Note that XXXXXXXXXXXX is the current name. If the
setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 3 key, the ENTER key and then using the alphanumeric keys,
enter up to 12 characters to refer to the first prompt and then press the ENTER key to
save the new setting and return to the ID Storage Menu.
4.PROMPT 2= (PROMPT 2 NAME)
With the ID Storage Menu displayed the current setting for the PROMPT 2=
parameter will be shown. Note that XXXXXXXXXXXX is the current name. If the
setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 4 key, the ENTER key and then using the alphanumeric keys,
enter up to 12 characters to refer to the second prompt and then press the ENTER key
to save the new setting and return to the ID Storage Menu.
5. PROMPT 3= (PROMPT 3 NAME)
With the ID Storage Menu displayed the current setting for the PROMPT 3=
parameter will be shown. Note that XXXXXXXXXXXX is the current name. If the
setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 5 key, the ENTER key and then using the alphanumeric keys,
enter up to 12 characters to refer to the third prompt and then press the ENTER key to
save the new setting and return to the ID Storage Menu.
ID Storage Setup Completed
1. With the ID Storage Menu displayed, press EXIT (Navigation Keys  UP Arrow) to return
to the Mode Of Operation Menu.
2. With the Mode Of Operation Menu displayed, press EXIT (Navigation Keys  UP Arrow)
to return to the SETUP MENU #1.
3. Press NEXT (Navigation Keys  Down Arrow) to proceed to the SETUP MENU #2.
4. Press EXIT (Navigation Keys  UP Arrow) to return to the SETUP/REVIEW MENU.
5. Press EXIT (Navigation Keys  UP Arrow) to reset the indicator and return to normal
operations.