Cardinal 225 - Ascii Commands

8200-M698-O1 Rev B  225 Installation and Technical
123
ASCII COMMANDS
The Model 225 indicator will respond to ASCII coded serial data, in the format below, when
input to the RXD serial input.
 The commands are ASCII strings, without spaces, followed by a carriage return <cr>
and can be upper or lower case, or any combination.
 Data inside parenthesis is the parameter item designator (e.g. “PWC (1) <cr>” requests
the value of PWC number 1 preset to be transmitted from the indicator).
 A command followed by the equal sign “=” is a set command and must be followed by
the data desired to be stored for that parameter.
 Any command without an equal sign requests data to be transmitted from the indicator
(a query command).
 Commands that set more than one value use commas between the values.
 To verify data has been stored correctly in the indicator, send the command to request
the same data to be transmitted from the indicator.
Commands
Command Response Description
Gross<cr> 1000lb G Transmit Gross Weight
Tare<cr> 100lb T Transmit Current Tare
Tare=123<cr> OK Set Tare To Value
Net<cr> 900lb N Transmit Net Weight
PWC (1)<cr> 100lb PWC1 Transmit PWC Value
PWC (1)=123<cr> OK Set PWC To Value
Fast<cr> 100lb F Transmit 2 Speed DFC Fast Value
Fast=123<cr> OK Set 2 Speed DFC Fast Value
Slow<cr> 100lb F Transmit 2 Speed DFC Slow Value
Slow=123<cr> OK Set 2 Speed DFC Slow Value
Fill<cr> 100lb F Transmit 1 Speed DFC Value
Fill=123<cr> OK Set 1 Speed DFC Value
Trim<cr> 100lb TRM Transmit DFC Trim Value
Trim=123<cr> OK Set DFC Trim Value
Accum(g)<cr> 1000lb
Transmit Accumulator Valid Selections
G/N/C/1-7
Accum(n)=100<cr> OK Set Accumulator
Ing(1)<cr> 1 100lb 1200lb Transmit Ingredient (Bin, Fast, Slow)
Ing(1)=1,100,150<cr> OK Set Ing (Bin, Fast, Slow)
Trim(1)<cr> 100lb TRM1 Transmit Batcher Trim For Ing X
Trim(1)=100<cr> OK Set Batcher Trim
ID()<cr> id(x)=r,1,2 List ALL IDs ID(ID)=Ref, Tare, Accum
ID(1)<cr> id(1)=r,1,2 List A Single ID
ID(1)=ref,100,0<cr> OK Add Or Replace An ID
Key(x)<cr> Results of (x) function.
Performs function of (x) as if key was
pressed. See Valid Key Names.
<cr> = carriage return