8200-M698-O1 Rev B 225 Installation and Technical
124
ASCII COMMANDS, CONT.
Valid Key Names
The following is a list of valid key names for the ASCII COMMAND Key(x).
Key Name Comments
asterisk or Use either the word “asterisk” or the symbol “”
0 to 9 Numeric characters
A to Z Uppercase alpha characters
a to z Lower case alpha characters
enter
time
net Toggles between Gross and Net weight modes
preset
count
tare Stores the current gross weight as the new tare weight.
(The same function as the diamond “T” key).
tarewt Displays the current tare weight for three seconds.
(The same function as the weight “T” key).
print
off
Turns the indicator off. (NOTE: The ON/OFF key on the
keypad must be pressed to turn the indicator back on).
zero
units
Toggles between the base units and converted units
selected during Setup and Calibration.
start
stop
mem
id
accum
delete
dump
gross
Selects Gross weight only, DOES NOT toggle between
Gross and Net weight modes. (See Net, above).
Error Responses
Response Description
?
Did not understand the command.
MODE This command not supported by the mode of operation.
For example: no Ing() if not batcher.
To Next Page
Loading...
