8200-M698-O1 Rev B 225 Installation and Technical
126
TROUBLESHOOTING, CONT.
COLD RAM
The external ram has failed to retain memory.
CORRECTIVE ACTION: Consult your scale service provider.
CAL LOST CONFIG REQUIRED SCALE X
EEPROM checksum failure. Indicates improper stored calibration data, calibration is
necessary. Note that X is the scale number (1, 2 or 3).
CORRECTIVE ACTION: Recalibrate with calibrated test weight.
ERROR
An invalid keypad entry was attempted:
A. PRINT key pressed with a negative weight.
B. TARE key pressed to enter a push button tare value of a negative value.
C. ENTER key pressed to enter a tare weight value that exceeds the scale capacity.
D. ENTER key pressed to enter a tare weight value that is inconsistent with the scale
division value (i.e. attempt to enter a tare of 123 with scale divisions of 5).
E. ZERO key pressed when the gross weight is outside the scale zero weight range.
F. lb/kg key pressed to change to kilograms when the kilogram tare weight value exceeds
4 digits in length.
CORRECTIVE ACTION: Determine which of the reasons for the error display is applicable
and take the appropriate corrective action.
A2D ERROR
¤ ¤ ¤ ¤ ¤ ¤ ¤
The Analog to Digital converter chip has stopped producing weight.
CORRECTIVE ACTION: Consult your scale service provider.
DRDY ERROR
¤ ¤ ¤ ¤ ¤ ¤ ¤
The Analog to Digital converter chip is not responding.
CORRECTIVE ACTION: Consult your scale service provider.
FILE FULL
The operator is attempting to add an ID when the ID file is full.
CORRECTIVE ACTION: Determine the reason for the error display and take the
appropriate corrective action.
To Next Page
Loading...
