8200-M698-O1 Rev B 225 Installation and Technical
127
TROUBLESHOOTING, CONT.
HUH?
UNITS key pressed in an attempt to perform a “unit” conversion that is not allowed.
CORRECTIVE ACTION: Determine the reason for the error display and take the
appropriate corrective action.
ID IN USE
The operator is attempting to add an ID that already exists.
CORRECTIVE ACTION: Chose another number for the ID.
ID NOT FOUND
The operator is attempting to use an ID that does not exist.
CORRECTIVE ACTION: Determine the reason for the error display and take the
appropriate corrective action.
NO TARE
NET key pressed with no stored tare weight value.
CORRECTIVE ACTION: Determine the reason for the error display and take the
appropriate corrective action.
OVERFLOW
¤ ¤ ¤ ¤ ¤ ¤ ¤
The indicator is attempting to display a positive number greater than seven (7) digits in
length or a negative number of more than six (6) digits.
CORRECTIVE ACTION: Return to Gross Weight mode and review Tare value. May
indicate miscalibration.
TOO BIG
UNITS key pressed in an attempt to perform a “unit” conversion where the interval would
have been greater than 50.
CORRECTIVE ACTION: Determine the reason for the error display and take the
appropriate corrective action.
TOO SMALL
UNITS key pressed in an attempt to perform a “unit” conversion where the interval would
have been less than .0001.
CORRECTIVE ACTION: Determine the reason for the error display and take the
appropriate corrective action.
To Next Page
Loading...
