8200-M698-O1 Rev B 225 Installation and Technical
7
INSTALLATION
Before beginning installation of your Model 225 Weight Indicator, make certain that it has been
received in good condition. Carefully remove it from the shipping carton and inspect it for any
evidence of damage (such as exterior dents or scratches) that may have taken place during
shipment. Keep the carton and packing material for return shipment if it should become
necessary. It is the responsibility of the purchaser to file all claims for any damages or loss
incurred during transit.
Mounting
NOTE: Should your 225 indicator come already installed on a scale, the following information
describing the installation of the indicator does not apply.
The Model 225 Indicator is housed in a Stainless Steel wall or desk-mount enclosure. The 225
gimbal may be mounted on a desk, table or other smooth, flat, horizontal surface or may be
mounted on a wall. Refer to Figure No. 1 for a layout of wall mounting.
If wall mounted, make certain the mounting surface is strong enough to support the instrument.
The mounting location should be where the display is easily viewed while being close enough
to provide the operator easy access to the keypad. Carefully lay out the mounting hole
locations, then drill and install the anchor bolts. Attach the gimbal to the wall and securely
tighten the retaining bolts.
Figure No. 1
Clearance for
#10 size screw
To Next Page
Loading...
