8200-M698-O1 Rev B 225 Installation and Technical
10
INSTALLATION, CONT.
9. Repeat the procedure until all wires are in place.
10. After all terminations have been made, remove the excess cable from the enclosure.
11. Referring to Figure No. 6, fold the shield wire back over the plastic insert and then insert
the plastic insert (with the shield wire) into the gland connector.
12. The shield wire is secured when tightening the gland connector nut. See Figure No. 7.
13. Do not over-tighten the connector but make certain it is snug.
Figure No. 7
Figure No. 6
Shield
Wire
To Next Page
Loading...
