8200-M698-O1 Rev B 225 Installation and Technical
39
ANNUNCIATORS
The annunciators are turned on to show that the indicator is in the mode corresponding to the
annunciator label or that the status indicated by the label is active.
0 (ZERO)
This annunciator is turned on to show that the
weight is within +/- 1/4 division of the center
of zero.
(STABLE)
This annunciator is turned on when the
weight display is stable. This indicates the
change in successive weight samples is less
than the motion limits selected during
Calibration and Setup.
G (GROSS)
This annunciator is turned on to indicate that
the displayed weight is the Gross weight.
NET
This annunciator is turned on to show that the
displayed weight is the Net weight (Gross
weight less Tare weight).
T
This annunciator is turned on to indicate that
the displayed weight is the tare weight.
To Next Page
Loading...
