8200-M698-O1 Rev B 225 Installation and Technical
52
CALIBRATION AND SETUP, CONT.
5. CONT=XXX (COM0 CONTINUOUS OUTPUT)
With the COM0 SETUP MENU displayed the current setting for the CONT= parameter
will be shown. Note that XXX is the current value. If the setting displayed is
acceptable, proceed to the next setup parameter.
Otherwise, press the 5 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to the COM0 SETUP MENU.
CONT=YES CONT=NO
Continuous Output Enabled Continuous Output Disabled
NOTE: If you selected CONT=NO (Continuous Output Disabled) for the CONT=
parameter, the following setup parameters 6. TYPE=, 7. SCALE= and
8. Gross Only= will NOT be shown on the COM0 SETUP MENU.
6. TYPE=X XXXXXXXXXX (COM0 CONTINUOUS OUTPUT SELECTION)
With the COM0 SETUP MENU displayed the current setting for the TYPE= parameter
will be shown. Note that X is the current value and XXXXXXXXXX is the description. If
the setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 6 key, the ENTER key and then using the numeric keys, enter the
value for the COM0 continuous output selection and then press the ENTER key to save
the new setting and return to the COM0 SETUP MENU. Allowable values are 0 through
6 and 10.
0 = SMA 3 = IQ355 6 = SB250/500M
1 = SB400 4 = NUMERIC WT 10 = SB200
2 = TOLEDO (See Note) 5 = SB500
NOTE: If you selected 2. TOLEDO for the TYPE= parameter, the following setup menu
parameters will be shown after pressing the ENTER key:
PRINTR CONTINUOUS OUTPUT SELECTION
TOLEDO FORMAT SELECTION MENU
0. 8530 no CKSUM
1. SHORT no CKSUM
2. 8530 with CKSUM
3. SHORT with CKSUM
TOLEDO Format=X
To Next Page
Loading...
