8200-M698-O1 Rev B 225 Installation and Technical
62
CALIBRATION AND SETUP, CONT.
PRINT TABS SETUP
With SETUP MENU #1 displayed, press NEXT (Navigation Keys Down Arrow) to proceed to
SETUP MENU #2.
SETUP MENU #2
1. SERIAL
2. DIO
3. PRINT TABS
4. SETUP SCALE 1
5. CALIBRATE 1
Enter Selection: 0 ` NEXT ^ PREV
3. PRINT TABS (PRINT TABS SETTING)
With the SETUP MENU #2 displayed, press the 3 key and then the ENTER key to proceed
to PRINT TABBING MENU #1.
PRINT TABBING MENU #1
1. PORT=X XXXXXXX 6. TIME=YY.XX
2. PRT BEG=XXXXXXXXXXXX 7. DATE=YY.XX
3. AUTO LF=XXX 8. CNC NO=YY.XX
4. ENDING LF=XX 9. GROSS=YY.XX
5. PRT END=XXXXXXXXXXXX 10. TARE=YY.XX
Enter Selection: 0 ` NEXT ^ EXIT
1. PORT=X XXXXXXX (SELECT PORT FOR PRINTER)
With PRINT TABBING MENU #1 displayed the current setting for the PORT=
parameter will be shown. Note that X is the current value and XXXXXXX is the
description. If the setting displayed is acceptable, proceed to the next setup parameter.
Otherwise, press the 1 key, the ENTER key and then using the numeric keys, enter the
value for the port the printer will be connected to and then press the ENTER key to save
the new setting and return to PRINT TABBING MENU #1. Allowable values are 0
through 3.
0 = COM0 1 = COM1 2 = COM2 3 = COM3
To Next Page
Loading...
