Cardinal 225 - Page 97

8200-M698-O1 Rev B  225 Installation and Technical
89
CALIBRATION AND SETUP, CONT.
3. Thres Wt=XXXXXXX (THRESHOLD WEIGHT FOR BADGE READER)
With the BADGE READER SETUP Menu displayed the current setting for the
Thres Wt= parameter will be shown. Note that XXXXXXX is the current value. If
the setting displayed is acceptable, press EXIT (Navigation Keys  UP Arrow) to return
to the Serial Menu.
Otherwise, press the 3 key, the ENTER key and then using the numeric keys, enter the
value for the threshold weight used to allow the badge reader to work and then press
the ENTER key to save the new setting and return to the BADGE READER SETUP
Menu.
If you selected 1 = AWID for the TYPE= parameter on the BADGE READER
SETUP Menu, the following setup parameter will be shown.
4. SITE ID= (SITE ID REQUIRED)
With the BADGE READER SETUP Menu displayed (and TYPE=1 (AWID) set) the
current setting for the SITE ID= parameter will be shown. Note that XXX is the
current value. If the setting displayed is acceptable, proceed to the next setup
parameter.
Otherwise, press the 1 key, the ENTER key, YES or NO (on the soft keys) and then the
ENTER key to save the new setting and return to the BADGE READER SETUP Menu.
SITE ID=YES SITE ID=NO
Badges must have 3-digit Site ID to
be valid
Badge Reader will work without
Site ID on badges