8200-M698-O1 Rev B 225 Installation and Technical
91
CALIBRATION AND SETUP, CONT.
LOCAL REMOTE PORT
NOTE: Although shown on this example of SETUP MENU #3, the setup
parameter LRPort= will only be displayed when TYPE=SERIAL has been
selected in SCALE 1 SETUP MENU #1.
SETUP MENU #3
1. G/N ACCUMS=XXX 6. KEY LOCKOUT
2. BACK LITE= X 7. LRPort=COM3
3. PASSWORD
4. 2XX-
5. BADGE RDR
Enter Selection: 0 ^ PREV ` EXIT
7. LRPort= (LOCAL REMOTE PORT)
With the SETUP MENU #3 displayed the current setting for the LRPort= parameter
will be shown. This is the serial port the indicator will use for the Local/Remote
connection. Note that COM3 is the current port shown. This is the system default port.
If the setting displayed is acceptable, press EXIT (Navigation Keys Down Arrow) to
return to the SETUP/REVIEW MENU.
Otherwise, press the 7 key, the ENTER key and then using the numeric keys, enter the
value for the serial port the indicator will use for the Local/Remote port and then press
the ENTER key to save the new setting and return to the SETUP MENU #3. Allowable
values are 1, 2 or 3. NOTE: 3=COM3 is the default setting.
SETUP MENU #3
Select Local-Remote Port
1=COM1 2=COM2 3=COM3
LR Port=3
With the SETUP MENU #3 displayed,
Press PREV (Navigation Keys UP Arrow) to return to SETUP MENU #2.
Press EXIT (Navigation Keys Down Arrow) to return to the SETUP/REVIEW MENU.
To Next Page
Loading...
