1780-M057-O1 Rev C Hydraulic Floor Stand Tank/Hopper
RECOMMENDED SEALING PROCEDURE
If your Guardian Hydraulic Scale System is used in a commercial application and your local
metrology laws require the use of physical sealing, a lead and wire security seal can be
installed to prevent access to the interior components of the Totalizer Enclosure.
To prevent access to the interior components, refer to the illustrations below and seal the
enclosure as follows:
1. Install the sealing tab before the “O” ring.
2. Tighten the screw.
3. Bend the tab as shown.
4. Install sealing wire.
5. Pull the wire tight and install the lead seal.
6. The screw can not be removed without damaging the seal.
Note that the sealing tab and screw are available from the Cardinal Scale Mfg. Parts
Department.
PARTS LIST
8530-B159-08 SEALING TAB
6021-1708 SCW FILLISTER. MACHINE-SCW 10-32X.75
To Next Page
Loading...