What to do if the user is bottoming out on Care of Sweden CuroCell IQ Cirrus?
If a user is 'bottoming out' on your Care of Sweden Personal Care Product, restart the control unit and allow it to complete its automatic setting. Then, perform a hand check. If the gap is still too small, gradually raise the comfort setting. If the problem persists, it is recommended to contact Care of Sweden or your local distributor.
Why is the control unit of Care of Sweden Personal Care Products making noise?
If the control unit of your Care of Sweden Personal Care Product is making noise or causing vibrations, first check how it's hung on the bed, as resonance can cause vibrations. Try removing the control unit to see if the noise stops. If so, place the unit on a flat, steady surface or put a towel between the unit and the bed. If the problem continues, contact Care of Sweden or your local distributor.
How to troubleshoot a Care of Sweden CuroCell IQ Cirrus control unit that does not start?
If the control unit of your Care of Sweden Personal Care Product doesn't start, verify that the power supply is properly connected to the mains and that the LED on the power supply shows green.
General| Category | Personal Care Products |
|---|---|
| Intended Use | Pressure ulcer prevention and treatment |
| Max. Patient Weight | 250 kg |
| Mattress Height | 18 cm |
| CPR Function | Yes |
| Number of Air Cells | 17 |
| Weight Capacity | 250 kg |
| Waterproof | Yes |
| Modes of Operation | Static |
| Cell Material | Polyurethane |
| Cover Material | Vapour-permeable PU |
| Product Type | Alternating Mattress |
| Technology | Alternating Pressure |
| Control Unit | Digital |
| Power Supply | 220-240V |
To Next Page