controller default replace the controller
E06 over voltage
Input voltage too low Please check whether the power
supply line is normal
Failure of controller board replace the controller
E07
safety key did not put
well
safety key fail off the treadmill put the safety key well
the safety system default replace the console
Maintenance and Malfunction Treatment
1) The surface of the treadmill should be kept clean, remove the power cord
before cleaning. You can clean the tread and surface of the treadmill with a
soft, damp cloth.
2) The treadmill is factory set, it may not work properly after transport or use.
Stop the treadmill before adjusting, pull the treadmill to the centre and adjust
the left and right rear roller bolts with a hex key (see figure). It is recommended
to adjust one half turn at a time. Then turn the switch and check if the mat is 10
turns off when the speed is about 4 to 5 km/h.
Warning: To prevent electrical shock, make sure the treadmill is turned off and
unplugged before cleaning or performing routine maintenance.
LUBRICATING THE TREADMILL AND DECK
To extend the life of this treadmill, the treadmill requires regular lubrication, which is general maintenance for the
machine. The routine maintenance procedure will prevent premature wear of the treadmill and motor system. The
recommended lubrication schedule is as follows:
LUBRICATION USE
1-6 km/h Every 6 months
6-12 km/h Every 3 months
12-16 km/h Every 2 months
This schedule corresponds to the recommended application for an individual user, up to 20-30 minutes at a time, 3-4
times a week.
CLEANING
Perspiration should be wiped off the console and treadmill surface after your workout. You should wipe your treadmill
once a week with a soft, damp cloth. Do not over-moisten the display panel as this may cause electrical and electronic
problems.
STORAGE
Store your treadmill in a clean, dry place. Make sure it is turned off and the plug is unplugged.
MOVING
This treadmill has been designed and equipped with wheels for easy movement. Before moving it, make sure it is
turned off and the plug is unplugged.
FOR HOME USE ONLY!
This treadmill is designed for home use only. Do not use in an institution or for commercial purposes.
MAINTENANCE LUBRICATION
It is important to take care of your treadmill (especially the running surface underneath the treadmill). Proper silicone
lubrication will also improve the performance of your treadmill.
WARNING: Turn off the treadmill and remove the safety key before lubricating the running surface.
HOW TO APPLY SILICONE TO THE TREADMILL
A/ Find the bottle of silicone. It is located in the DIY kit included with this treadmill.
B/ Find a straw and place it on the silicone bottle as shown in the drawing.
To Next Page
Loading...