Tips before use!
1. Voltage requirements, please charge this camera no more than 5V 1A/2A adapter after
receiving it. E.g. USB of PC also OK.
2. Storage the camera in dry and clean with packaged well. Wipe printer head dirty, press
printer head and push back cover tightly if have lines on paper.
3. Make sure you have the paper the right way. Print blank if wrong feeding.
4. Avoid Moisture, Direct Sunlight, High Temperatures environment, and Friction for
pictures’ storage.
5. Sticking out the paper a bit out of the camera and enable print mode before printing.
6. Transfer or clean up data in SD card timely to avoid excessive data or camera stuck.
A: 1. Enter the Setting by clicking 'OK' button
2. Click the Next/Previous Button to find a printer icon
3. Click the Next/Previous button to select a particular Print Density(from 0-4), clicking the
'OK' button. PS. Switch DOT Print to Grayscale Print can create different styles.
A: Enable/Disable print mode.
1. Enter the Photo mode
2. Press OK button, a printer icon display/disappear on right corner, it means to enter/exit
print mode.
3. Then press the CAMERA button to take photos.
Click Play Back. Find the picture, Hold the OK button for a few seconds. Then the deletion
displays. Click OK button.
A: Please search Careenoah kids camera paper roll.
A: Charge the camera or Reset.
1. Full charge it with 5V/1A adapter for 2 hours. the indicator light on.
2. Press OK button to power on and off.
3. When screen stuck, please pull out the SD Card if have data, then RESET. (Use a
needle to press Reset Slot near to SD Card slot.)
A: Please ensure enable the print mode and pull the paper out of slot a bit.
Press OK button, a printer icon display on right corner, it means to print mode.Then you
can print. And pull the paper out of slot to avoid jammed.
To Next Page
Need help?
General
