Carel gaSteam UG045 - Page 56

ENG
Menu D. Inputs/outputs
Menu Index Description Level
Analogue inputs D01
Values read by main probe, limit probe, boiler water temperature,
feedwater conductivity
Installer,
Service
Digital inputs D02
Read status of remote On/Off, motor protector, level sensor float
position, foam sensor
Installer,
Service
Analogue outputs D03 Read current production
Installer,
Service
Digital outputs D04
Read status of unit On/Off, contactor, drain pump, fill valve,
SSR/fan
Installer,
Service
In/Out - WPrb 1
(In/Out wireless probe 1)
D05
Read temperature and/or humidity values
Read signal leveland battery level on probe 1
Installer,
Service
In/Out - WPrb 2
(In/Out wireless probe 2)
D06
Read temperature and/or humidity values
Read signal leveland battery level on probe 2
Installer,
Service
In/Out - WPrb 3
(In/Out wireless probe 3)
D07
Read temperature and/or humidity values
Read signal leveland battery level on probe 3
Installer,
Service
In/Out - WPrb 4
(In/Out wireless probe 4)
D08
Read temperature and/or humidity values
Read signal leveland battery level on probe 4
Installer,
Service
Menu E. Settings(password)
Menu Index Description Level
a. Control
Control type Ea01 Set the type of control Installer
Weights Ea02 Set the weight of the two probes Installer
Control proportional to external signal Ea03
Set the hysteresis, minimum
production and
maximum production
Installer
External ON/OFF Ea04
Set the maximum production with
external
ON/OFF control
Installer
Modulating control Ea05
Set the set point, differential, min
production,
max production
Installer
Integral function Ea05a
Set the integral time and the neutral
zone
Installer
Limit probe Ea06 Setthe set point and differential Installer
Boiler operating hours Ea07
Display boiler operating hours
Reset hour counter and set
maintenance pre-alert threshold
Service
Burners rotation Ea10 Set the burner activation sequence Installer
b. Functions
Enable preheating Eb02
Enable preheating
Set the water temperature to maintain
Set the offset
Installer
Partfill cycles Eb03
Enable part fillcycles
Set part fill time
Installer
Drain do to inactivity Eb04
Enable drain due to inactivity
Set the inactivity threshold
Installer
Periodical drain Eb05
Enable periodical drain cycles
Set the threshold for the periodical
drain cycles
Installer
M5 Signal. M6 Signal Eb07
Enable the output relay for unit status
(production) or maintenance pre-alert
Installer
Blower unit Eb08 Set on and off delay for blower unit Installer
Export logs Eb09
Save the log of main variables to USB
pen drive
Service
Installer
Export Alarms Eb10 Save alarm log to USB pen drive
Service
Installer
56|6. Start-up and user interface
gaSteam - UG +0300090EN rel. 1.2– 09.10.2018