Carel gaSteam UG045 - Page 58

ENG
Menu Index Description Level
Display Master/ Slave system Ed08
Unit status with relative production as a
%. Press “PRG” to configure the
Master/Slave network
Installer
Display info on individual unit. Unit 1,
Unit 2, ...,Unit 20
Ed09
Display unit operating hours, current
production and any alarms
To move between the various units use
the UP and DOWN arrows
Installer
Unit switched-off for maintenance Ed10
Unit switched off to carry out
maintenance
Installer
e. Backup
Enable backup Ee01
Enable automatic unit backup in the
event of shutdown, using a second
independent unit
Installer
Priority when starting Ee02
Define the priority of the units when in
backup mode
Installer
f. Manual mode
Manual mode Ef01
Enable manual mode: Disabled,
manual management of outputs and
manual request
Service,
Installer
Manual management of outputs Ef02
Test the outputs: fill valve, drain pump,
...
Service,
Installer
Manual request management Ef03 Manually set the production request
Service,
Installer
g. Initialisation
Wizard Eg01
Start the wizard for initial unit
configuration
Set whether to display the wizard when
next restarting
Service,
Installer
Language Eg02 Set the language
Service,
Installer
Unit of measure and language when
starting
Eg03
Set unit of measure (International or
Imperial). Select the language when
starting
Installer
Change password Eg04
Change the password (Service,
Installer).
Service,
Installer
Inst. default Eg06
Unit factory reset. Warning, when
changing the model all the control
settings will be lost and the values will
return to the factory defaults
Service,
Installer
Software update Eg07
Update the unit software from USBpen
drive
Service,
Installer
Export parameters Eg08
Export the unit configuration
parameters to a USB pen drive
Service,
Installer
Importparameters Eg09
Import configuration parameters from
USBpen drive to the unit
Service,
Installer
h. Supervisor
Unit supervision address on BMS port Eh01
Set the unit address for supervision.
Enable and set type of supervisor
protocol
Installer
BMS port configuration settings Eh02
Set the communication parameters for
supervision via BMS: Baud rate, stop bits
and parity
Installer
BACnet MS/TP configuration Eh03
Set the address, maximum number of
masters and maximum number of
frames
Installer
Device Inst. Eh06
Device inst. configuration for BACnet
protocol
Installer
Ethernet network settings Eh04
Set DHCP, IP address, mask, gateway,
DNS for the Ethernet network.
Important: these values must be
provided by the local network
administrator
Installer
Supervsion settings on Ethernet port Eh05
Select the protocol on the Ethernet
port: ModBus or BACnet
Installer
58|6. Start-up and user interface
gaSteam - UG +0300090EN rel. 1.2– 09.10.2018