Carel humiSonic - Quick Access Menus

23
ENG
“humiSonic ventilation” +0300063EN - rel. 1.3 - 14.05.2021
5.7 Quick access menus
The quick access menus can be used to rapidly access the unit information
and settings.
Procedure:
1. Press Esc one or more times to return to the standard display;
2. Press UP/DOWN to show the required quick access menu icon;
ICON
Info On/Off Set point*
Tab. 5.f
(*) Only shown if control with probe is selected for Fa01.
3. Press Enter to enter the menu, UP/DOWN to scroll, ESC to exit.
5.6.1 Info
Read-only screens that display the main unit information:
• Humidifier size;
• Waiting time until the next wash;
• Operating hours with atomised water production;
• Total unit operating hours;
• Float level sensor status: low, working (normal operation), high;
• Dipswitch status on the control board;
• Status and operating hours of the Secondary units (if there is a Main/
Secondary connection)
• Preheating probe reading (if enabled);
• Replicate request and related voltage signal for multi-Main connection.
50.0rH%
Production 0.5Kg/h
90.0rH%
29/05/2015 Fri 12:30
Humidifier size:
0.5Kg/h
Next Wash : 22h
Info i01
Fig. 5.e
5.6.2 Set point
Only shown if control with probe has been selected (Fa01).
On this screen, the control set point for humidity / temperature probe
and limit humidity probe set point can be set.
50.0rH%
90.0rH%
29/05/2015 Fri 12:30
Setpoint
Production 0.5kg/h
Setpoint : 50.0rH%
Limit : 90.0rH%
Fig. 5.f
5.6.3 On/O
Unit On/Off from the keypad.
50.0rH%
90.0rH%
29/05/2015 Fri 12:30
rH%
90.0rH%
29/05/2015 Fri 12:30
Production 0.5kg/h
Disabled
Off by key
--.-
Fig. 5.g