EasyManua.ls Logo

Carel Large ROL 160-1K2 - Advanced Settings and Maintenance Intervals

Carel Large ROL 160-1K2
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
50
ENG
Control
WTS LARGE +0300131IT rel. 1.0 - 05.09.2022
11.6.11 Module ushing
In this submenu you configure the module flush(es).
Four flushing procedures can be programmed:
At start-up of production
During shutdown of the production
During production at a programmed time interval
In standby mode against standstill germination (same
time interval as during production)
10 SOFTENER
11 CLEANING
11A WASHING
ENABLED
» Press the arrow keys éê to select if relay
input should be active or inactive.
» Confirm the selection with
.
The program jumps to submenu "11B".
11B PUMP
YES
By pressing the arrow keys éê you set whether the
high pressure pump should run during flushing.
Yes = Pump ON
NO = Pump OFF
» Confirm the selection with
.
The program jumps to submenu "11C"
» Default value: PUMP NO
11C EVIN
YES
Press the arrow keys éê to select, if a flush should be
done when production is started up.
YES = active
NO = inactive
» Confirm the selection with
.
The program jumps to submenu "11D".
» Default value: EVIN YES
11D START PROD.
ENABLED
By pressing the arrow keys éê you set whether a flush
should be carried out before each start.
» Confirm the selection with
.
The program jumps to submenu "11E".
11E TIME
00min 00sec
By pressing the arrow keys éê you set the duration of
the flushing time.
» Confirm the selection with
.
The program jumps to submenu "11F".
11F END PROD.
ENABLED
By pressing the arrow keys éê you set whether a flush
should be carried out at the end of the production.
» Confirm the selection with
.
The program jumps to submenu "11G".
11G TIME
0min 15sec
By pressing the arrow keys éê you set the duration of
the flushing time for the periodic module flushing.
» Confirm the selection with
.
The program jumps to submenu "11H".
» Default value: 01 min 00 sec
11H WASHCYCLE
0min 15sec 24h
By pressing the arrow keys éê you specify the time
period between the periodic module flushes.
e.g. change 24h to 48h (usage pause)
» Confirm the selection with
.
The program jumps back to the main menu.
» Default value: 00 min 30 sec 24 h