Caroma International Pty Ltd. ABN 90 35 053 413 157
Date of Issue: May 2019
Standard Wax Bowl
Ring
Reducing Wax Bowl
Ring
Fig.2
Sydney Smart II One Piece
1.28/0.8 gpf (4.8/3 lpf) Easy
Height Elongated Toilet
#987150
Vitreous China Dual Flush
High Efficiency (HET)
Washdown Toilet
Closet Flange
Finished Wall
12" or 10"
(305mm or 255mm)
Closet Flange
Wax Seal
Finished Wall
12" or 10"
(305mm or 255mm)
'T' Bolt
Adaptor
Finished Wall
12" or 10"
(305mm or 255mm)
Fixing
Fixing
Bracket
Caravelle Bowl
Cap
Stainless Steel Screw
Brass Bushing
Plastic
Bushing
Fig.1
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
Fixing Bracket Assembly
2"
(50mm)
11"
(280mm)
12”(305mm)
10”(255mm)
7-1/2”
(185mm)
13/16”
(20mm)
29-15/16”
(760mm)
18-1/2”
(470mm)
5-1/2”
(140mm)
14-1/8”
(360mm)
30-3/8”(770mm) approx.
16-1/2”(420mm)
18”(455mm) to top of seat
3/4”
(20mm)
21-1/4”
(540mm)
10-3/4”
(272mm)
Rough in:
It is possible to fix the toilet into a 10” (255mm) or 12” (305mm)
rough in position by rotating the offset adaptor.
IMPORTANT:
A reducing wax ring MUST NOT be used when installing this
toilet bowl as detailed in Fig.2.
Working Water Pressure:
USA & Canada: Recommended working water pressure is
20-80psi (140-550Kpa).
Installation Procedure:
PLUMBER’S INSTALLATION INSTRUCTIONS. PLEASE
READ CAREFULLY BEFORE INSTALLATION.
1. It is important for installation of Sydney Smart II 1 PC
Washdown toilet that the closet flange be accurately set
out from the finished wall as detailed in Fig.3.
2. Position wax seal and offset adaptor onto “T” bolts as
detailed in Fig. 4 and 5, ensuring that the offset adaptor is
positioned for a 10” (255mm) or 12” (305mm) rough in as
detailed in Fig.1.
4. Ensure that the area around the closet bowl is clean and
free from building materials.
7. It is recommended that a bead of silicone caulking is
applied fully around base of the closet bowl.
3. Place fixing bracket onto “T” bolt and secure it by hand,
tightening nuts and washers onto the “T” bolts. Apply an
additional turn for final installation as detailed in Fig.5.
5. Accurately align the closet bowl over the offset adaptor
and lower into position.
8. Remove any excess silicone caulking.
6. Insert the plastic bushing and brass bushing into the Bowl
fixing hole as shown in Fig.6. Secure the bushings through
the holes in fixing bracket with stainless steel screws as shown
in Fig. 7. Cover the holes with caps.
Flushing Operation:
Push down the big button for a full flush (1.28 gpf / 4.8 lpf)
and the small button for a reduced flush (0.8 gpf / 3 lpf).
Need help?
To Next Page
General
