10
der Rundenzähler automatisch ab.
Set lap race mode
1
If the preset lap counter has to be changed, please proceed as fol-
lows: When the display flashes, please press the
C
button. The
units position of the lap number will start to flash. By pressing the
E
button, the number of the units position can be changed. (fig.
2
)
2
By pressing the
C
button again, the display will jump to the tens
position (fig.
3
). Using the
E
button, the tens position can be set.
3
Finally, by pressing the
C
button again, the display will jump to the
hundreds position. The hundreds position can now be set via the
E
button (fig.
4
).
4
Set time trial mode
1
In order to set a time trial, first switch to the time mode by pressing
the
E
button. The last set time is shown and the display will start
to flash (fig.
1
). By pressing the
C
button, the units position of the
time display will flash (fig.
2
) meaning that the units position for the
number of seconds can be set with the
E
button.
2
By pressing the
C
button again, the display switches to the tens
position (fig.
3
). The tens position for the number of seconds can
now be set with the
E
button.
3
In the next step, the units position for the minutes can be set. To
do this,press the
C
button until the units position of the minutes
flashes. To do this, press the
E
button to enter the required time
(fig.
4
).
4
Then the tens position of the minutes is set. Press the
C
button
until the tens position starts to flash. Set the required minutes using
the
E
button (fig.
5
).
5
Start phase
Once all settings have been undertaken, press the
C
button to
initiate the start phase.
The numbers on the display will flash (fig.
1
)
1
Pressing the
C
button again will start the countdown.
The 5 red LEDs will switch on one after the other and the display will
also count down (fig.
2
).
2
Once all 5 LEDs have been deleted and the display counted down,
the race can be started.
To Next Page
Loading...
Need help?
General
