Carrier 160 Series - Page 28

CHIMNEY INSPECTION CHART
For additional requirements refer to the National Fuel Gas Code NFPA 54/ANSI 2223.1 and ANSI/NFPA 211
Chimneys, Fireplaces, Vents, and Solid Fuel Burning Appliances
58CV
Crown :
condition: Rebuild
Missing mortar crown.
or brick?
I
Is chimney No
property lined with
clay tile liner?
Yes
Is Repair :
liner and top No , liner or top seal Reline .
seal in good * or reline chimney as P
condition? necessary.
Yes Repair
Debris
in cleanout? Yes Mortar
Mortar, tile, metal vent, or tile Nes Remove ent >
fuel oil residue? debris?
4 No | Remove metal vent
or liner. No
Clay
tile misalignment, Yes b>
missing sections, .
aps?
gap Consult
“ PartBof Not Suitable
No chimney adapter venting
instructions for
application
suitability. c.
Condensate
Is chimney
lined with properly
Line chimney with property
sized, listed flexible metal
drainage at bottom ; ; ;
of chimney? sized, listed liner or liner or Type-B vent per
¥ Type-B vent? NFGC Vent
es : Sizing Tables and liner or
adapter
per’
vent
manufacturers
No orerusticns Installation instructions.
. Not Suitable
Chi Consult
mney
Is
chimney
No
Part
C
of
;
ounce below p< to be dedicated to V_V_y “Chimney adapter ventingS Suitable
time? a single instructions for
roof line? Yes furnace? application
suitability
NV
No Install chimney
adapter per
instructions.
Chimney is a vv Vv
acceptable for use.
Fig. 35 - Chimney Inspection Chart
A10133