To Rig Compressor
Note: The motor end of the 19XL compressor is heavy and will tip backwards unless these
directions are followed:
1. Remove rigging bar (Figure 6, Item 4) and the bolts securing it.
2. Place the rigging bar vertically over the compressor end bell (Figure 6, Item 5). Attach the
rigging bar to the compressor end bell using the 2 bolts removed in Step 1.
Additional Notes
1. Use silicon grease on new O-rings when refitting.
2. Use gasket sealant on new gaskets when refitting.
3. Cooler and condenser vessels may be rigged vertically. Rigging should be fixed to all 4
corners of the tube sheet.
Click here for Figure 8 — 19XL Refrigerant Return
Click here for Figure 9 — 19XL Oil Reclaim System
To Next Page
Loading...
