Press the HUMIDITY button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
HUMIDITY
Press
After your humidification system has been operating for the number of
days set in step #12 below, the Service Humidify icon will appear. This
counter keeps track of the number of days since the Service Humidify
icon was reset.
Viewing the Humidification Run-TimeViewing the Humidification Run-Time
Counts the number of
days the humidifier has
been running. Press
FAN to reset the
Service Humidify
counter and remove the
icon from the display.
Press
FAN
0
Service
Setup
I2
Humidify
Page 10.3
Note: Press the MODE
button momentarily
to move through the
setup screens. Press
and hold the MODE
button to move back-
wards through the
setup screens.
10
HUMIDITY
MODE
MODE
Press the MODE button. While holding
the MODE, press the HUMIDITY button
to enter Setup screens.
Press the MODE button repeatedly
until this setup screen appears.
To Next Page
Loading...
