UNIT OPERATION
I TIMER OPERATION
I ON Timer I
PROCEDURE
I
®
0
qg., -"_,
FLAP FAN
Qo.
" 5:BB
ON/OFF SLEEP
MODE FAN FLAP
c;j c-n
,
rTIMER_
oN off RESERVCANCELi
_- ,,j
®
®
1
2
3
4
ONTIMERbutton
Pressthis button.
At the beginning, time isset at 6:00 A.M.
HOUR,MINUTEbuttons
Pressthese buttons to set the operation start-up time
you want duringthe ON Timer symbol is flashing.
RESERV.button
Press this button pointing the remote controller
towards the receiver of the indoor unit.
• A receiving beep is heard.
• TIMER lamp of the indoor unit lights on.
FANSPEED,MODEbuttons
Set the desired operation mode withthese buttons.
I About ON Timer I
• When the ON Timer is set, unit monitors the room
temperature before 1 hour from set time to make
the room as set condition at reserved on time
• The actual on time of unit is decided at 0 to 40
minutes earlier than reserved on time according to
the room temperature and size.
NOTE
• The current time is not indicated during the reservation of ON/OFF Timer.
• When you want to know the current time, press the CLOCK button and you can see the current time for 5
seconds.
• If you reserve the ON Timer during operation, the unit will stop operation.
Please cancel the on timer to operate continuously.
(Refer to p.18)
15
To Next Page
Loading...
