38MGRBQ: Service Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
91
2 FAN ASSEMBLY REMOVE THE FAN ASSEMBLY REMARKS
1. Remove the top cover, the right front side panel and front
panel as shown in section 1, steps 1-4.
2. Remove the hex nut securing the fan.
3. Remove the fan,
4. Remove the electrical control box cover.
5. Disconnect the fan motor connector CN14(5p,white) from
the IPM board.
6. Remove the 4 screws, then remove the fan.
To Next Page
Loading...
