b. Wireless Remote Control
The unit is factory equipped with a wire harness that has one end connecting to the receiver board (Display PCB) and the other
end is loose. See Fig. 32.
4---- Loose
5 4J_ 2 1 1S
1_12131_1511_12131_151A
I Jll I I J8 I I Js I
Fig. 32 - Wire Harness
End
A09547
To modify the unit for use with wireless remote do the following:
a. Remove the cover of the Internal Control Panel to get access to the microprocessor board. See Fig. 33.
®
®
INTERNAL CONTROL PANEL INTERNAL CONTROL PANEL
40KMC018 40KMC024-036
40KMQ018-036
@ Capacitor [] Fan connector
@ GMC board [] LED/RECEIVER connector
@ Electric heater board
(only on modets with etectdc heater) [] Float connector
@ Transformer [] Pump connector
@ Holes for fixing panel in position [] Louver connector
@ Emergency push-button
Fig. 33 - Internal Control Panel
b. Unplug the J5 connector (A) from the board (see Fig. 32).
c. Plug the Loose end (B) into the J5 Connector on the board
d. Reinstall the cover of the internal control panel
A07180
20
To Next Page
Loading...
