Carrier 40MBAB - Page 16

40MBAB: Installation Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
16
ELECTRIC AUXILIARY HEAT MODULE
INSTALLATION AND WIRING
1. Remove the upper cover and use professional tools to remove the
upper cover knock-outs.
A220792
Fig. 43 — Remove the Upper Cover
2. Remove the terminal block and power cord.
3. Loosen the screws.
4. Remove the electric auxiliary heating cover.
A220793
Fig. 44 — Remove the Terminal Block and Power Cord
5. Install the electric auxiliary heating component into the chassis shell
along the front of the unit.
NOTE: Insert the front end into the shell assembly hole.
A220794
Fig. 45 — Install the Electric Auxiliary Heating
Component
Top View