13
INSTALLATION OF THE DECORATION PANEL
Detach the intake grill
1. Slide the two grille hooks toward the middle of the
decoration panel.
1 Intake grille
2 Grille hook
1
2
Fig. 24 --- Intake Grille
2. Open the intake grille and remove.
Fig. 25 --- Open Intake Grille
Install the decoration
panel
1. Align the indication marks “
” on the decoration panel to
the indication marks “
” on the unit.
2. Attach the decoration panel to the unit with the supplied
screws (see Fig. 26).
1 Decoration panel
2 Screws (M5)(supplied with the panel)
1
2
Fig. 26 --- Attach the Decoration Panel
3. After installing the decoration panel, ensure there is no space
betwee n the unit body and the decorati on pane l. Otherwise air
ma y le ak through the gap a nd ca use de wdrops ( s ee Fig. 27).
Fig. 27 --- Eliminate Space
4. Mount the intake grille. Ensure the buckles at the back of
the grille are properly seated in the panel’s groove.
Fig. 28 --- Mount the Intake Grille
5. Connect the decoration panel’s two wires to the unit’s
mainboard.
10-core wire5-core wire
Fig. 29 --- Connect two wires
To Next Page
Loading...
