Carrier 40MHH - Advanced Functions and Settings; Sleep Function Operation; SET Function for Mode Selection; Follow Me Comfort Function

40MHH: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
14
Sleep Function
or
FRESH Function( ) (some units) :
AP Mode ( ) (some units) :
Follow me function ( ) :
SET Function
SET
SET
OK
Press SET to enter the function setting, then press SET or TEMP or TEMP
to select the desired function. The selected symbol flashes on the display area, press OK to confirm.
To cancel the selected function, just perform the same procedures as above.
Press SET to scroll through operation functions as follows:
Fresh ( ) Follow Me( ) AP mode( )
[ ]: If your remote controller has the Fresh function, you can not use the SET button to
select the Fresh function.
J
J


The FOLLOW ME function enables the remote control to measure the temperature at its current location
and sends this signal to the
air conditioner under a every 3 minutes interval. When using AUTO, COOL or
HEAT modes, measuring ambient temperature from the remote control (instead of from the indoor unit itself)
allows the air conditioner to optimize the temperature around you and ensure maximum comfort.
The SLEEP function is used to decrease energy while occupants sleep (and do not
require the same temperature settings for comfort). This function can only by
activated via the remote control.
Note:
The SLEEP function is not available in FAN or DRY mode.
When the FRESH function is initiated, the Ionizer/Plasma Dust Collector (depending on models)
is energized and helps to remove pollen and impurities from the air.
If the memory feature is stopped, “OF” displays for 3 seconds on the screen.
While the memory feature is activated, press ON/OFF, shift the mode or power failure will not cancel
the FOLLOW ME function.
NOTE: Press and hold Turbo for seven seconds to start/stop the Memory feature of the FOLLOW ME
function
If the memory feature is activated, “ON” displays for 3 seconds on the screen.
SLEEP Function
Press SLEEP
Choose AP mode to perform wireless network configuration. For some units, it does not work by pressing
the SET button. To enter the AP mode, continuously press the LED seven times in 10 seconds.