Carrier 40QQ Series - Page 18

18
Fig. 24 - Honeywell 7220 Connections
23. Check all wiring for safety then reapply power to the
unit. Verify correct operation and setting of the
accessory(s) per the Configuration and Operations
sections of the instruction.
24. Install access door next to hood. Screw bottom of
door to HVAC unit (See Fig. 21). Use standard
serrated screws along bottom of panel for all units.
25. Replace the i ndoor fan motor access panel.
26. Install the hood filter by opening the filter clips,
which are located underneath the hood top. Insert the
aluminum filter into the bottom filter rack (hood
divider). Push the filter into position past the open
filter clips. Close the filter clips to lock the filter into
place (See Fig. 21 and 22).
EconoMi$er X
Hood
Horizontal
Blank-Off
Front Blank-Off Panel
Fig. 25 - Horizontal Return Opening Blank- Off Panel
40QQ