Carrier 40VMM Series - Indoor Unit Addressing

22
Click TEMP. UP or TEMP. DOWN to change 00 to the
desired address as shown in Fig. 37. Press OK to confirm and
exit the setting interface.
Programmable Controller (40VM900003) —
When setting an address, connect only one wired controller to
an indoor unit.
1. Press FAN and BACK simultaneously for 5 seconds to
access parameter settings as shown in Fig. 38.
2. Press TEMP. UP or TEMP. DOWN to move the cursor
and choose IDU ADDRESSING. Press MENU/OK to
access this setting.
3. Press TEMP. UP or TEMP. DOWN to choose the
address you want to set (see Fig. 39). Press MENU/OK
to send this address to the IDU.
4. Press BACK twice or wait 30 seconds to automatically
exit the parameter settings menu.
#
MODE
FAN TEMP. DOWN
OK
TEMP. UP ON/OFF
TIMER
ROOM TEMP.
SWING
Fig. 37 — Non-Programmable Controller
(40VM900002) Setting IDU Address
Fig. 38 — Programmable Controller
(40VM900003) IDU Addressing Menu
MODE
FAN
MENU
TEMP. DOWN
TEMP. UP
OK
BACK
ON/OFF
Fig. 39 — Programmable Controller
(40VM900003) Setting IDU Address
MODE
FAN
MENU
TEMP. DOWN
OK
TEMP. UP
BACK
ON/OFF