Carrier 42DH - Page 15

15
Fig. 22 — 42DH Unit Submittal Drawing
NOTES:
1. Right hand unit shown; left hand unit opposite.
2. All dimensions are ± 1/4 in.
3. Product specifications are subject to changes without notice.
4. Dimensions are in inches (mm).
5. Allow adequate spacing or maneuverability around unit to allow service through recommended access area.
6. C dimension is measured from coil side of unit.
7. Mixing box option will vary return duct dimensions, refer to mixing box drawing.
8. Auxiliary control box required with 3-speed EC motors and/or cabinet lighting option; not required with low voltage (0-10v) controls.
UNIT
SIZE
FAN
SIZE
DEPTH WIDTH HEIGHT
SUPPLY DUCT RETURN DUCT MOUNTING HOLES
AUX.
CTRL.
BOX
M
A B C D E F G J K L
06 9 x 6 36 28 19-3/4 8-7/8 10-7/8 13-3/4 2-1/4 24-1/4 14 2-3/4 27-1/4 35-1/4 5-3/4 2
08 9 x 6 36 28 19-3/4 8-7/8 10-7/8 13-3/4 2-1/4 24-1/4 14 2-3/4 27-1/4 35-1/4 5-3/4 2
10
9 x 6 37-1/2 37 21-1/2 10-1/4 10-7/8 14-1/2 2-1/4 33-1/4 15-3/4 2-7/8 36-1/4 37 5 2
12 9 x 6 37-1/2 37 21-1/2 10-1/4 10-7/8 14-1/2 2-1/4 33-1/4 15-3/4 2-7/8 36-1/4 37 5 2
16 10 x 7 37-3/4 47 21-1/2 13 12 18-3/8 2-1/4 43-7/8 15-3/4 2-7/8 46-1/4 37 1-1/4 1-1/2
20/22 11 x 10 40-1/4 48 24 16-1/4 13 17-1/4 2-1/4 44-1/4 18 2-7/8 47-1/4 39-1/2 2-3/8 2
30 12 x 12 40-1/4 48 32-1/4 16-1/4 14 16 7-1/8 44-1/4 26-1/2 1-1/4 47-1/4 39-1/2 3-3/4 2
NOTE: Drawing is not to scale and is provided
for reference only. Dimensions may vary
with options ordered.